Primera-technology Disc Publisher Pro Manuel d'utilisateur télécharger pdf (Page 32)

Center The Print Image

NOTE:

Your printer comes from the factory pre-calibrated to print

the image in the center of the CD. You can use this adjustment if you

need to fine-tune this location.

If you ever wish to verify your factory-calibrated Vertical

and Horizontal calibration settings, you can run a simple

calibration procedure to assure that your images will be

centered when printed on a CD. To do this, refer to the

following steps:

1. Verify that a disc and a color ink cartridge are installed

in the Publisher. It is important to use the same disc you

normally use for your publishing because different brands

of discs may vary slightly in size. Also, verify that the

Publisher is powered ON and that it is connected to your

computer.

2. Click on the Center the Print Image and then the

Properties button. The printer will begin printing the

calibration test print.

3. When the print is complete, rotate disc 180º

and put the disc back in the input bin and

repeat step 2 using the same disc.

4. When the second run of the print is complete, you should

have a test print that looks similar to the following:

-5 -4 -3 -2 -1 0 1 2 3 4 5

5 4 3 2 1 0 -1 -2 -3 4 -5

Horizontal Calibration

Find and enter the number

whose lines tough

(must be the SAME number)

Vertical Calibration

Find and enter the number

whose lines tough

(must be the SAME number)

NOTE:

After printing this image

once, rotate this CD

so the ARROWS point

to the BACK of the printer

and print again.

-5

-4

-3

-2

-1

-2

-3

-4

-5

BACK

28 Creating Discs on a PC

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 60 61

Commentaires sur ces manuels

Pas de commentaire

Primera-technology Disc Publisher Pro Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimeurs Primera-technology Disc Publisher Pro